From a manufacturable design to measured pilot units, board builds and a release pack a CM can run. One path across pilot production, PCB manufacturing and supplier handoff – not three separate vendors guessing at intent.
Turnkey means the process is owned, not just the quote.
BrahmWorks is a Bangalore hardware studio. Turnkey manufacturing is design plus the production steps that prove and release the product: controlled builds, electronics fab and assembly, and documentation that leaves tribal knowledge out of the plant. Scope follows quantity, materials and supplier fit – we build when it fits, and we hand off cleanly when your CM owns the line.
Three manufacturing services
Start on the page that matches the bottleneck. Most programs use more than one before release.
Pilot & low-volume
Build the first real units the way production will, measure yield, and close design or process gaps before a mass buy. EVT/DVT-style loops with records – not a larger prototype batch with no process.
Electronics / PCB
PCB fab, SMT or hand assembly, programming, test fixtures and packaging next to the electronics design. Prototype through higher volume as the board and supplier fit allow.
Supplier & CM handoff
Drawings, BOMs, process notes and release packs your contract manufacturer and vendors can build from – including when the CM is already yours.
When to engage
Start with the bottleneck, keep one release story.
Tell us where the product is stuck – pilot yield, board builds, or a CM that cannot build from the current pack. We map the path across the three services and the upstream design work on DFM, electronics and prototype-to-production. No invented case studies; scope is agreed before parts are ordered.
Questions we get
Is turnkey the same as mass production?
No. Turnkey here means we own or coordinate the manufacturing path for your product – pilot, boards and release – at the scale the design and suppliers support. Mass capacity is a separate claim; we state what a pilot or low-volume run has and has not proven.
Do we have to use all three services?
No. Use the child page that matches the need. Many programs start with DFM, then pilot or PCB builds, then a CM pack. The hub is the map; the three pages are the scopes.
Do you only manufacture, or also design?
Both. Upstream design sits on pages such as DFM & DFA, electronics design and prototype to production. Manufacturing issues feed those designs when they change the product.
Can you work with our existing CM?
Yes. See supplier and CM handoff. We do not require a vendor switch; the release pack is written for whoever builds.
Get Quote Now
Get a customised estimate for Product Development.
For more information about our tech stack, visit here.
Hardware Design Mandate
Hardware Design Mandate1:1 Meeting Setup
Schedule a one-on-one meeting with our Engineering team for personalised assistance and insights.
Schedule 1:1 Meeting
Schedule 1:1 MeetingReady to take the next step in your product development journey?
Connect
Contact Us
© 2026. Built with ♥️ in Bengaluru.